![]() ![]() If you are using Xilinx Platform Cable USB, ensure that status LED is green. In case of zynq board check whether Digilent/Xilinx cable switch settings are correct. Check whether the board is connected to the system properly. The error message: Program FPGA failed Reason: Could not find FPGA device on the board for connection 'Local'. ![]() But when I power the boards and choose program from Vitis it does not seem to see the Zynq 7000 in the programming chain and it does not program. ![]() The programming cable drivers seem to be loaded correctly in device manager, it is called Xilinx Embedded Platform USB Firmware Loader under Programming Cables. ![]() I have a digilent USB-JTAG programming cable rev G which I have checked is pin compatible with connector P19. I want to use the JTAG port P19 on the CRR-BOB to program the board from Vitis so I set switches S2 and S3 both to 0 on the ADRV9361 board. I have built the analog devices code in Xilinx for these boards sucessfully and loaded the C source code into Vitis and built that too. Hi, I have an ADRV9361-z7035 board and a ADRV1CRR-BOB base board. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |